C Variety Flex-Flex Couplings
The C Variety coupling consists of two flex hubs, one sleeve and a single accessory kit consisting of seals and snap rings.
CFR Type Flex-Rigid Couplings
The CFR Sort coupling include 1 flex hub, a single rigid hub, 1 sleeve, 1 accessory kit consisting of seals and snap rings.
Options
Uncomplicated and economical variety of gear coupling
All steel sleves and hubs
Reinforced rubber seals with snap rings to hold lubricant in area
Readily available as vertical and horizontal couplings
Wide selection of special variations like full-flex, flex-rigid mill motor
Regular configurations are available in the shelf
Ordering Facts
Application: Driver and Driven.
Type and size of coupling, horizontal, vertical and so on.
Energy: Motor horspower or torque requirement.
Speed: Motor RPM or Driven RPM.
Distance in between shaft ends (BSE).
Shaft sizes.
C and CFR Form Couplings
Ordering Information
Puller Holes are normal on sizes 4 through twelve.
Puller Holes can be found for sizes 7/8 as a result of three.five at an extra charge.
The BSE (distance Amongst Shaft Ends) may well vary amongst G and G1.
Interference bores 
without any set screws are typical except if otherwise specified.
Inch bores and keyway tolerances conform to ANSI / AGMA 9002-B04.
For metric bores and keyway tolerances, talk to Engineering Part.
Bigger sizes can be found, please seek advice from Technical Support.
C and CFR Variety Effectiveness Information
Tags