Materials Dealing with Energy UNIT two
This power unit capabilities electrical power up gravity down circuit. Activate the start solenoid to start the motor to lift the machine. The lowing movement is activated from the solenoid valve with all the lowering speed controlled through the pressure compensated movement control valve. Solutions of this series is usually widely used in the business of logistic products for instance fork lift, mini lift table, and so forth.
one. The duty of this energy unit is S3,i.e.,30 seconds on and 270 senconds off.
two. Clean all the hydraulic components concerned prior to mounting the electrical power unit.
three. Viscosity with the hydraulic oil shoud be 15~46 cst,which need to also be clean and free of impurities, N46 hydraulic oil is encouraged .
4. Oil transforming is needed immediately after the initial a hundred operation hrs,afterwards the moment every 3000 hrs.
five. The energy unit ought to be mounted horizontally.
Materials Handling Energy UNIT one
This electrical power unit is made to the fork lift industry, consisting of really productive gear pump, DC motor, guide raise and decrease valve, tank, ect. The up and down movement are managed by the lever in the manual release valve, which can be outfitted with an electrical switch to activate the motor. The lowing speed is controlled from the strain compensated movement control valve.
one. The duty of this power unit is S3, i.e. thirty seconds on and 270 senconds off.
two. Clean all of the hydraulic parts concerned before installation of the power unit.
3. Viscosity of your hydraulic oil shoud be 15~46 cst, which really should also be clean and no cost of impurities, N46 hydraulic oil is advised .
four. Oil shifting is required after the initial a hundred operation hours, afterwards after each and every 3000 hours.
five. The electrical power unit shown is built to be mounted horizontally.