Electrical power UNITS FOR LIFT TABLE

Electrical power UNITS FOR LIFT TABLE 1
Standard Description
This power unit is developed exclusively for your smaller lift table,Consisting of high pressure gear pump, AC motor, multi-functional manifold, valves, tank, etc. This energy unit has become broadly utilized inside the field of logistic devices including minifork lift, scissors lift and ariel functioning platforms. The lower-ing movement is controlled through the solenoid valve together with the velocity controlled through the adjustable needle valve.
Electrical power UNITS FOR LIFT TABLE two
Common Description
This electrical power unit is intended exclusively for that medium lift table, Consisting of really effecient gear pump, AC motor, multifunctional manifold, valves, tank, ect. The decreasing movement is actived through the solenoid valve as well as the pace controlled through the adjustable needle valve. When the lift rises to a high positoin, however the power supply is cut, the decreasing motion is managed by the manual override perform.
Power UNITS FOR LIFT TABLE three
General Description
This energy unit is designed exclusively for the significant lift table, Consisting of really effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The lowering movement is actived from the solenoid valve and also the pace managed by a stress compensated movement control valve.
Power UNITS FOR LIFT TABLE 4
Basic Description
This electrical power unit is designed solely for your massive lift table, Consisting of extremely effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The reducing motion is actived through the solenoid valve plus the pace controlled by the adjustable needle valve. When the lift rises to a higher positoin, but the power provide is cut, the reducing movement is managed by the manual override function.
Special Notes
one. This power unit is of S3 duty cycle, which could only perform intermittently and repeatedly, i.e. 1 minute on and 9 minutes off.
2. Clean each of the hydraulic elements concerned before installation of the energy unit.
3. Viscosity from the oil shoud be 15~46 cst,which should also be clean and absolutely free of impurities.N46 hydraulic oil is suggested.
four. Oil transforming is required just after the initial a hundred operation hours,afterwards when each 3000 hours.
5. The energy unit shown is built to be mounted vertically.

Tags

Gearbox-worm

As one of leading gearbox-worm manufacturers, suppliers and exporters of mechanical products, We offer gearbox-worm and many other products.

Please contact us for details.

Mail: [email protected]

Manufacturer supplier exporter of gearbox-worm.

Recent Posts